Page tree

Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Physical Configuration

Prior to the Pronto S1witch configuration, it is necessary to connect the switch to another equipment using a serial cable.

Installing and configuring Minicom

After connecting the switch to another equipment (where the operator must have access), it's necessary to install the Minicom software.

...

Warning

It's advisable to be aware of what kind of serial cable it's being used, since this may impact the minicom configuration.

Switch configuration - Control Plane Configuration

After configuring the minicom, the next step it's to configure the switch.

...

Info

For further information about the configuration of the control plane network, check this link: 2. FIBRENet's Control Plane - Network Configuration for Islands

After that, it's necessary to configure the gateway:

...

Code Block
themeMidnight
languagebash
reboot

Switch Configuration - OpenFlow Configuration

Also it's necessary to configure the Open vSwitch embedded in the Pronto Switch.

...